Brakes

675

BRAKE PAD INFORMATION
( B001 )

BRAKE PADS - We stock organic (Armstrong), Semi-sintered (Nissin NS - see picture left) and fully sintered (DP and Nissin ST - see picture left) brake pads. Organic pads are resin bonded, kind to the discs, generally quieter and fine for general road use. Sintered pads are made from metal particles put under pressure and heat, offer the best stopping power, but also cause the most rotor wear and can make the most noise. Virtually all original equipment pads are now sintered. They are also the least affected by adverse conditions and are the pad to choose for high speed and track days. Sintered pads can feel 'grabby' and may lack 'feel' at the lever. Semi-metallic pads fall right in the middle for durability and performance. A trade off between sintered and organic, they still stop well, cause less rotor wear with better lever feel than sintered metallic pads and normally make less noise.

Nissin brake pad compound chart shown left.



Contact Us For Details

Rear Brake Master Cylinder Rebuild Kit
( B010 )

Rebuild kit for all Triumph (Nissin) rear brake master cylinders.

Fits America, Bonneville 800/865, T100, 600/650/675/750/900/955/1000/1200 Daytona, 750/900 Trident, 750/900/955/1050 Speed Triple, 900/1200 Trophy, Scrambler, Speed Four, Speemaster, Street Triple, Thunderbird 900, Legend, Adventurer, Thunderbird Sport, Sprint 900, Sprint Sport, Sprint Executive, Sprint ST 955/1050, Sprint GT, 955 Sprint RS, Street Triple, Tiger 800/900/955/1050, Tiger 800, Tiger XC, TT600



£26.95
More info  

4 piston front caliper seal kits for Nissin and Triumph calipers
( B056 )

Fits all Nissin and Triumph front 4 piston calipers on all (Apart from Brembo) Triumph sports and touring models. Kit contains 8 seals (4 outer dust seals and 4 hydraulic seals). To equilize brake pad wear, these calipers use 2 different piston sizes, 30mm (leading) and 34mm (trailing). Use silicone or rubber grease during assembly after cleaning out any corrosion from the dust seal groove. The joint seals on the 2 halves are now also included. The piston seals are genuine Nissin parts as used as original equipment by Triumph. These seals are also used in the 1/2 Nym spec. Triumph calipers. Made in Japan.

Fits: 600/650/675/750/900/955/1000/1050/1200/2300



£22.95
More info  

Earls brake hose to order
( B076 )

Earls stainless steel braided hose with neatly crimped stainless steel ends can be supplied to order for every model. We charge per hose with the choice of clear, black or no covering on the braiding. Popular models are stocked, others to order in approximately 3 or 4 days. Hoses are supplied with new copper banjo sealing washers. Recently produced models from Triumph are equiped with braided hoses (although the ends are plated not stainless steel) for reduced lever travel over earlier models with their reinforced rubber hoses. Custom lengths no problem. 

Earls stainless steel braided hose with stainless steel banjo crimped ends with new copper sealing washers. 600/650/750/800/865/900/955/1000/1050/1200/2300. Priced per hose. Please state model when ordering.





£29.95
More info  

Front brake reservoir container.
( B193 )

Genuine Nissin front brake reservoir plastic pot used many Triumph models. This inclues the link pipe which fits some but no all models.

Fits  TT600, Speed Four, 600/650/675/955 Daytona, T595, T509, Thruxton, SE, Bonneville (from vin 380777) , 955/1050 Speed Triple, Sprint 955 ST/RS, 1050 Sprint ST, Tiger 1050, Sprint 1050 GT.



£19.99
More info  

Angled inlet to master cylinder with seat/circlip kit
( B194 )

Angled inlet to front brake reservoir used on most sports models. The 'O' ring seal and circlip are the same components used in the inlet to Nissin rear brake master cylinders. Genuine Nissin component. Made in Japan.

Fits TT600, Speed Four, 600/650//955 Daytona, T595, T509, Thruxton, SE, Bonneville (from vin 380777) , 955 Speed Triple, 1050 Speed Triple (up to VIN 461331), Sprint 955 ST/RS, 1050 Sprint ST, Tiger 1050, Sprint 1050 GT



£17.95
More info  

Rear brake master cylinder boot Nissin.
( B226 )

Replacement master cylinder boot to fit all Nissin rear brake master cylinders. 



£4.95
More info  

Brake bleed screw covers
( B286 )

x 3 rubber bleed screw covers.



£1.95
More info  

Brake paste
( B292 )

Brake paste, ideal for brake pad pin threads.



£1.95
More info  

Brake Banjo Bolt Stainless Steel (Single)
( B429 )

Single banjo width Earl's stainless steel brake banjo bolt for most application where x 1 hose is fitted.

M10 x 1.25 pitch thread.



£4.95
More info  

Brake Banjo Bolt Stainless Steel (Double)
( B430 )

Double width banjo stainless steel bolt for x 2 hose connection. Examples are front brake splitter on 3 and 4 cylinder carburettor models.

M10 x 1.25 pitch thread.



£5.49
More info  

Brake Banjo Annealed Copper Washers 10 mm
( B432 )

Original style copper washer 10 mm bore, 15.70 outer diameter and 1.20 mm thick. Pack size 10 pieces. Made in USA.



£3.95
More info  

27mm caliper piston and seals (Stainless Steel)
( B436 )

Stainless steel caliper piston 27 mm diameter and 31 mm long with seals for x 1 caliper (x 2 pistons and x 4 seals). These are not genuine Nissin parts.

Fits front and rear calipers on Thunderbird 900, Legend, Thunderbird Sport, Adventurer, 750/900 Trident, 900/955 Tiger, Bonneville, T100, Thruxton, America, Speedmaster, SE, Scrambler, Trophy 900 and Sprint 900 up to vin 9083, Trophy 1200 up to vin 4902

Fits rear caliper only on 750/900/1000/1200 Daytona, 955 Daytona (single sided swinging arm model), 750/900/955/1050 Speed Triple, 900 Sprint Sprint Sport, Sprint Executive, 955/1050 Sprint ST, Sprint RS (single sided swinging arm), Sprint GT, Tiger 1050, Tiger 1050 SE, Trophy 900 and Sprint 900 from vin 9084, Trophy 1200 from vin 4903

Fits front caliper Tiger 800, Tiger XC, Street Triple 675,



£44.95
More info  

Piston Set 1/2 Nymfron
( B446 )

Set of x 4 Nissin caliper pistons (x 2  30 mm pistons and x 2  34 mm Nymfron low friction pistons). Can be fitted to any Nissin/Triumph 4 piston caliper (not Brembo). Nissin only coat the 34 mm to reduce friction/drag. This was done to help eliminate the long lever travel problems.



£54.00
More info  

Rear Caliper Piston and Seal kit 38 mm (pattern)
( B448 )

Pattern caliper piston and seals to fit rear calipers on all sports twin sided swinging arm models.

Fits TT600, Speed Four, Daytona 600, Daytona 650, Daytona 675, Street Triple, Daytona 955 (twin sided swinging arm model), Tiger 800, Tiger XC,



£24.00
More info  

Brake pad pin rear Nissin Tiger 800, TT600, Daytona 955
( B609 )

Rear brake caliper pad pin and screw cover fits Nissin rear calipers on:

Daytona 600/650, 675 Daytona to VIN 564947, Daytona 995 (twin sided swinging arm model only), Speed Four, Street Triple and Street Triple R up to VIN 560476, Tiger 800, XC, XCA, XCx, XR, XRT, XRx, TT600



£7.99
More info  

Disc Bolt 10 mm shoulder 30 mm long
( B810 )

Stainless steel disc bolt M8 x 1.25 mm pitch. Thread length 30 mm including 10 mm shoulder.

Fits front and rear on:

Bobber, Bonneville T120, Daytona 750/900/1000/1200, Daytona 600/650, Daytona 675, Daytona 955 (twin sided swinging arm), Rocket III, Speed Four, 750/900 Speed Triple, Sprint 900, Sprint Executive, Sprint Sport, Sprint RS (twin sided swinging arm), Street Cup, Street Scrambler, Street Triple 675, Street Triple R, S RS, Thruxton R (liquid cooled), Tiger 800, Tiger 1050, 750/900 Trident, 900/1200 Trophy, TT600

Fits front only on:

Daytona T595, Daytona 955 (single sided swinging arm), Speed Triple 955/1050, Sprint RS (Single sided swinging arm), Sprint ST 955/1050,



£5.49
More info  

Brake pad Armstrong Bonneville, Thunderbird 900, Tiger 800/955
( B902 )

Armstrong semi metallic brake pads.

Fits the front of the following: Bonneville, T100, Scrambler, Speedmaster, America, Thunderbird 900, Legend, Adventurer, Thunderbird Sport, Tiger 800, Tiger XC, Tiger 900 (injection), Tiger 955, 675 Street Triple (not R model)

Fits the rear of the following: Thunderbird 900, Legend, Adventurer, Thunderbird Sport, Tiger 900 (injection), Tiger 955 (up to vin 198874)

Supplied as 2 pads for x 1 caliper



£12.95
More info  

Brake pad Armstrong Bonneville (rear), 955, 1050, 900 left front
( B911 )

Armstrong brake pads. Supplied as 2 pads for x 1 caliper.

Fits the rear of the following: Tiger Explorer, Bonneville, T100, Scrambler, America, Speedmaster. All single sided models T595 Daytona, 955 Daytona, T509, 955 Speed Triple, 1050 Speed Triple, 955 Sprint ST, 1050 Sprint ST, Sprint 955 RS (single sided swinging arm models), Trophy 1215 & SE, Tiger Sport

Fits the front left side of the following: 750/900 Trident, 900 Trident Sprint and Trophy 900 up to vin 9082, Trophy 1200 up to vin 4901



£12.95
More info  

Brake pad rear Nissin 675 Daytona, Street Triple, Tiger 800, TT600
( B914 )

Nissin NS semi metallic rear brake pad.

Fits the rear of the following: TT600, Speed 4, Daytona 600, Daytona 650, Daytona 675, Street Triple, Street Triple R, Daytona 675 R, Daytona 955 (twin sided swinging arm), Tiger 800, Tiger XC,



£32.95
More info  

Rear Brake Pads 675, TT600, Tiger 800, Street Triple
( B915 )

Nissin NS semi metallic rear brake pad.

Fits the rear of the following: TT600, Speed 4, Daytona 600, Daytona 650, Daytona 675, Street Triple, Street Triple R, Daytona 675 R, Daytona 955 (twin sided swinging arm), Tiger 800, Tiger XC,



£12.95
More info  

Lever Clamp/Mirror Support
( C195 )

Replacement clamp/mirror support or new clamp for models with no mirror fixing. Used as original on clutch and front brake lever on 955/1050 Speed Triple, Speed Four, Thruxton, SE, Bonneville (from vin 380777), 955/1050 Tiger. Ideal to hold mirrors when converting Daytona 955/T595 to Speed Triple. 10mm threaded lever clamp used on many unfaired models for mirror fixing.  Made in Japan. 

Fits: Bonneville (from VIN 380777), SE, Scrambler, Speed Four, Speed Triple 955, T509, 1050 Speed Triple, Street Cup, Street Scrambler, Street Triple, Street Triple R, Street Twin, Thruxton 900, Tiger 1050



£9.95
More info  

Front Discs Daytona 675, Street Triple, TT600 and Daytona 600/650
( D010 )

x 2 replacement front discs to fit TT600, Speed Four, Daytona 600, Daytona 650, Daytona 675 and Street Triple. Made in UK.

 



£249.00
More info  

Rear Disc 220 mm T595, T509, 955 Daytona, 955 Speed Triple
( D016 )

220 mm rear disc to fit TT600, Speed Four, Daytona 600, Daytona 650, T595, T509, 955 Daytona, 955 Speed Triple, 1050 speed Triple, 675 Daytona and Street Triple.



£69.00
More info  

Front Brake Switch all models
( Z303 )

Original front brake switch made by Alps Electrical Co, Japan to fit all Nissin front brake master cylinders except only the radial brake models. 

Fits: Adventurer, America, Bonneville 800/865, T100, SE, Legend TT, Rocket III, Classic, Roadster, Touring, Scrambler, Speed Four, Speed Triple 750/900, Speed Triple T509, Speed Trilpe 955, Speed Triple 1050 up to VIN 461331,  Speedmaster, Sprint 900, Sprint Sport, Sprint Executive, Sprint St 955, Sprint RS, Sprint ST 1050, Sprint GT, Street Triple, Thruxton, Thunderbird 900, Thunderbird Sport, Thunderbird 1600/1700. Thunderbird Storm, Tiger 800, Tiger 800XC, Tiger 900, Tiger 955, Trident 750/900, Trophy 900/1200, TT600   



£11.95
More info