Sprint ST 1050 & GT
Set of x 5 cush rubbers. Replaces Triumph T1224400
Fits: Daytona T595, 955 Daytona, 955 Speed Triple, 1050 Speed Triple, 955 Sprint RS (single sided swinging arm), 955 Sprint ST, 1050 Sprint ST, Sprint GT, 1050 Tiger Sport
Gearbox sprockets available in 17, 18 or 19 teeth for all carburettor 3/4 cylinder models, all 955 and all 1050 models. Smaller than standand gives improved acceleration at the expense of fuel consumption and on some models increased chain guide wear. Larger than standard engine sprockets lose out slightly on acceleration but have a more relaxed feel in top gear. Please state size when ordering. (530 chain size).
530 VX gold heavy duty X-ring DID chain with sprockets, tab washer and sprocket cover gasket if required. Please state model when ordering and if in doubt just let us know what sprocket sizes you would like. (530 chain size). Front/rear/chain length details given are for standard factory sizes. Other size choice no problem.
Original equipment DID VX X-ring gold chain 530 size (5/8 x 3/8). Fits all 750, 900 (3/4 cylinder),1000, 955, 1200 and 1050 models.
Gearbox sprocket tab (locking) washer to fit all of the Bonneville range (carburettor and EFI), 955, 1050 and 3/4 cylinder carburettor models. Replaces Triumph T1180181
Fits 750/900 Trident, 900/1200 Trophy, 750/900/1000/1200 Daytona, Super III, 900 Tiger, 750/900 Speed Triple, 900 Sprint, Sprint Sport, Sprint Executive, Thunderbird 900, Thunderbird Sport, Legend, Adventurer, T595, 955 Daytona, T509, 955 Speed Triple, 955 Sprint ST, 955 Sprint RS, 955 Tiger, 1050 Tiger, Tiger Sport, 1050 Sprint ST, 1050 Sprint GT, 1050 Speed Triple, Bonneville 800/865, T100, Scrambler, America, Speedmaster, Thruxton and SE.
Tab Washer Gearbox Sprocket 3 and 4 cylinder carburettor models, 955, 1050.
Rear sprockets available in 42, 43, 44 or 45 teeth to fit all single sided swinging arm models. Please state size when ordering. (530 chain size).
T595. T509, 955 Daytona, 955/1050 Speed Triple, 955/1050 Sprint ST, 955 Sprint RS (single sided swinging arm)
Replica DID chain rivet tool. This will push the rivet link together and neatly rivet the ends over. To separate an old chain or shorten a chain, grind the rivet ends one side of the link to be removed until the side plate is hit. Go slightly below the surface to be sure the rivetting is well ground away, then knock apart with a punch and hammer.